Filter
Top Products
52
Setting your terminal
These two addresses must be filled in for the Scan To Disk function
(refer to paragraph Scan to Disk, page 84).
2538 OK - SETUP / NETWORKS / LOCAL NETWORK /
WINS 1
2539 OK - SETUP / NETWORKS / LOCAL NETWORK /
WINS 2
+ Enter the IP address of each server, then validate with OK.
Remark : If the terminal is set up in Automatic configuration mode (2531), these
addresses can be filled in automatically by certain DHCP servers.
SNTP server configuration
The terminal can automatically update its date and time when
connecting to an SNTP server.
Server address
2551 OK - SETUP / NETWORKS / SNTP SERVER /
ADDRESS
+ Enter the name of the SNTP server, then validate with OK.
This name can be in the form of an IP address, a DNS address or a
NetBIOS name.
Server port
2552 OK - SETUP / NETWORKS / SNTP SERVER /
PORT
+ Enter the server port number, then validate with OK.
The port by default is port 123.
Activating the server access
2553 OK - SETUP / NETWORKS / SNTP SERVER /
STATE
+ To activate the SNTP server, select WITH in the drop-down
menu then validate with OK.
Time zone
2554 OK - SETUP / NETWORKS / SNTP SERVER /
TIME ZONE
+ Select the time zone where the terminal is located from the
drop-down list then validate with OK.
If you have activated the automatic summer time management
(menu 212), the TIME ZONE setting is initialised automatically.