Filter
Top Products
Operation
90
Scanner and printer settings
841 OK - ADVANCED FCT / COPY / RESOLUTION
+ The RESOLUTION parameter adjusts the photocopying resolution. Select
HIGH SPEED, QUALITY or PHOTO RESOLUTION using keys or , then
validate the choice with the OK key.
842 OK - ADVANCED FCT / COPY / ZOOMING
+ The ZOOM setting is used to reduce or enlarge part of the document by
choosing the original and the zoom value to apply to the document, 25
to 400 %. Enter the zoom value required using the keys of the digital
key pad. Validate the choice with the OK key.
+ The special zoom values (141, 97, 94, 78, 71) are displayed with
explanatory text (xx->yy).
+ You can enter any zoom value at any time via the numeric keypad; if
the value entered does not correspond to a special value, the
explanatory text disappears.
+ If a special zoom value is entered again, the explanatory text should
reappear.
+ Validating a choice with the OK key will cause this choice to be set as
the default value and a 10-second time delay to be set for the
photocopier; if activated before the end of this time delay, the next local
copy will have this same zoom value applied as a default.
+ Validating a choice with the COPY key will cause the local copy slip to
be entered with the selected zoom value.
843 OK - ADVANCED FCT / COPY / ASSEMBLED
+ The ASSEMBLED parameter is used to define the choice of your printer
outputs; either assembled or not assembled. Validate the choice with
the OK key.
844 OK - ADVANCED FCT / COPY / ORIGIN
If you wish, you can change the origin of the scanner.
By entering new values of X and Y given in mm (X < 210 and Y < 286), you
will move the scanning zone as shown on the figure below.
+ Select the X and Y coordinates with keys or .
END OF SHEET
TOP OF SHEET
scanned area