Filter
Top Products
165
Various System Settings Section 6-9
(For the bar code reader, refer to page 184.)
• Comm. B Select page 162
• Comm. B Method page 152
For details on each setting, refer to the pages indicated.
6-9-2 Setting the Start-up Wait Time
The Start-up Wait Time is the time lapse until the NT631/NT631C switches to
the RUN mode after its power has been switched ON or after it has been
reset. Set this item if it takes some time for the host to start operation. Nothing
is displayed during the Start-up Wait Time.
The setting range is 0 to 10 seconds. The default (factory) setting is 00sec.
Set the system start-up wait time by following the menu operation from the
System Menu shown below.
To set other memory switches, select the relevant screen using the [ ] (next
screen) or [ ] (previous screen) touch switch, then make the setting.
• To confirm the settings and quit the memory switch setting screen, press
the Quit touch switch. The settings made last will be set and the NT631/
NT631C will return to the MAINTENANCE MODE MENU screen.
• To quit the memory switch setting screen without confirming the settings,
press the Abort touch switch. The NT631/NT631C will return to the MAIN-
TENANCE MODE MENU screen with the previous settings still in effect.
Select Maintenance Mode.
Select Memory Switch.
01 02 03 .... 09 10 00 01 ....
Ver 4.12
Press Start-up Wait Time to display the
required time lapse.
The setting option changes each time
the touch switch is pressed, according
to the following sequence.