Filter
Top Products
36
Setup Utility
press
To run the Setup Utility, you
need to restart your computer.
NOTE
The Setup Utility will not be run if is not pressed soon after the computer restarts.
In this case, you need to restart your computer again.
If is displayed, enter your password.
If both the [User Password] and [Supervisor Password] have been set, after entering the
User Password, [Supervisor Setup] will not be displayed on the main screen.
To display the [Supervisor Setup]:
1
Use + Power Switch to turn your computer off.
2
Restart the computer and press when [Press F1 for Setup] is displayed.
3
When is displayed, enter the Supervisor Password.
For more details, on-line help is available; press .
Setup Utility
•System Setup
•Power Management
•Supervisor Setup
Save Settings
Restore Settings
Load Default Settings (PnP)
Load Default Settings (Non-PnP)
Exit Setup
Set default settings.
• (PnP) denotes “for Windows 95”.
• (Non-PnP) denotes “for other than Windows 95”.
• When the Supervisor Password has been set, input of
the password is necessary.
Return to the state existing at the time of Setup Utility
startup, or to the settings saved with [Save Settings].
Program Completion
• Hibernation settings (
page 11)
• Power Management settings (
page 13)
• Security Settings (
page 17)
• Add-ons/Peripherals Settings (
page 22)
After you have completed all settings, you may
exit the Setup Utility program.
Closing the Program
Running the Setup Utility
Exit Setup
Settings were changed.
Do you want to save them?
Yes, save and exit the Setup Utility.
No, exit the Setup Utility without saving.
No, return to the Setup Utility.
NOTE
If the User Password has been set, the password
must be entered before Windows can start.
(The display may be different if no changes to the settings are made.)
<Main Screen>
Key Operations
NOTE
: To display the correspond-
ing “help” file.
: To make a selection.
: To display previous screen
(To exit the program at the
main screen).
: To move among the items.
: To move among the values of
each item.
: To return to the setting before a
change.
: To set the default values.
Press F1 for Setup
Upon seeing
this message