Filter
Top Products
24
CAUTION
CAUTION
Using PC Card
PC Card Utility Program
1
Set [Sound Controller] to [Automatic (PnP)] in the Setup Utility.
2
Select [Start] - [Run].
3
Type [c:\util\drivers\pccard\setup.exe], press [OK], then follow the on-screen in-
structions.
About PhoenixCard Manager
TM
for Windows
®
95
If a ZV card does not operate properly, install PhoenixCard Manager
TM
for Win-
dows
®
95 by following the procedure below, after uninstalling the driver or the appli-
cation software for the card.
Otherwise, do not perform the installation; abnormal operation may result.
When running the power conservation function with the sound chip set,
there may be no sound output. In this case, the following setting needs to
be made.
In [Control Panel] - [Power] - [OPL3-SAx power management], set [Non Power
Save mode] then press [Apply]. Then press [OK]. ( page 41)
After PhoenixCard Manager
TM
for Windows
®
95 has been installed, make sure to
power off the computer before installing or removing the card. Also, do not use
the suspend or hibernation functions if the card is installed.
Installing (only if the ZV card does not operate properly)
Uninstalling
When you decide not to use the ZV card, be sure to perform the uninstall proce-
dure.
1
Uninstall PhoenixCard Manager
TM
for Windows
®
95 in [Start] - [Settings] - [Con-
trol Panel] - [Add/Remove Programs].
2
Restart the computer.
3
Select [PC Card (PCMCIA)] in [Start] - [Settings] - [Control Panel].
4
Press [Next] at the display for the [Display Driver Wizard for PC Cards (PCMCIA)],
press [Next] again and then press [Finish].
5
Shut down the computer by following the on-screen instructions.
NOTE