28
CAUTION
1
Do not install or remove peripherals while your computer is in the
suspend or hibernation mode; abnormal operation may result.
Connect the external display to your computer
Do not shut down using the suspend or hibernation mode.
Power off your computer ( "Starting Up/Shutting Down")
Run the Setup Utility ( page 34)
Using and , select [Display], select the display to
use with , then press Esc
Using and , select [System Setup], then press
Enter
Close the Setup Utility
( page 34)
Turn on the external display, then turn on your computer
with the display opened
3
1
2
3
4
External Display Port
Using an External Display
Select your external display
4
Set your external display for [Monitor] in [Start] - [Settings] - [Control
Panel] - [Display] - [Settings] - [Advanced Properties].
When a monitor that does not conform to the Plug & Play standards is
connected, select [Change] and make the monitor settings.
You can select either an external display, LCD or simultaneous with Fn
+ F3 .
In addition, you can set the display to use during start-up with the follow-
ing procedure.
For more detailed information, please refer to the operation manual of
the external display.
2
NOTE