Filter
Top Products
46
Dealing With Problems
is displayed
[Supervisor Setup] is not
displayed in the menu
[User Password] cannot
be selected
[Coffee break Password]
or [Key Combination for
Coffee break] cannot be
selected
[Supervisor Password]
cannot be set
Setup Utility
Enter the User Password or Supervisor Password. If you have forgotten it, contact
Panasonic Technical Support.
At the start of the computer when is displayed, you have to enter the Supervisor
Password. When both the User Password and Supervisor Password have been set,
if you enter the User Password, [Supervisor Setup] will not be displayed.
If [Supervisor Setup] is not displayed even after entering the Supervisor Password,
you have to delete the User Password. Run the Setup Utility again, and input the
Supervisor Password.
[User Password Protection] in [Supervisor Setup] may be enabled.
You need to set the User Password.
If the User Password has been set first, the Supervisor Password can not be the
same as the User Password. Another password needs to be entered.
Press Ctrl + Alt + Del to reboot the computer.
After cutting the power by pressing the sleep switch for more than four seconds,
slide the power switch to power on and open the application again.
If the program no longer works normally, go to [Start] - [Settings] - [Control Panel]
- [Add/Remove Programs] to delete the program. Then, try installing the program
once again.
Computer hangs
Application Software
When using the computer as a network computer, some additional settings may
have to be made depending on the usage conditions. We recommend asking your
system administrator or the person in charge of the network.
Unable to connect to a
network
Network
Character Input
Unable to input anything
but numerals
Only capital letters are
being input
How to input European
characters (ß, à, ç) or
symbols is unclear
If NumLk and Key Pad are on, the Numeric Key Pad is ON. To switch it OFF,
press Fn + Key Pad .
If CapsLock is on, the Caps Lock function is ON. To switch it OFF, press
Caps Lock .
Select [Start] - [Programs] - [Accessories] - [Character Map]. The Character Map will
be displayed. Point to the desired font name and select it.