Filter
Top Products
Panasonic Wireless Display Configuration Manual
5. A Enter the SSID of your Access Point.
B Change the network type to [Infrastructure].
C Enter the PC IP address, Display IP address, and Subnet mask. [ P.12-(4)]
D Enable the WEP to [64 bits]. (If your Access Point does not uses WEP or use
128 bits encryption, change the "WEP" to [Disabled] or [128 bits] respectively.)
E Click the [Key(s)...] button. The window shown below will appear. Enter the
WEP key of your Access Point here. Set the "Default Key" to the one you wish to
use. Click [OK] to exit out of the window.
F Enable the AES to [128 bits]. (If you do not want to use AES encryption, use 192
bits encryption, or use 256 bits encryption, change the "AES" to [Disabled], [192
bits], or [256 bits] respectively. )
G Click the [Key...] button. The window as shown below will appear. To use phrase
generated AES key, select "Phrase" and enter a phase in the box. To enter the
AES key directly, select "Binary" and enter your AES key in the box. Click [OK] to
exit out of the window.
H Check the "Use this profile now" box so that "Profile 2" will become the active
profile after the setup is completed.
This screen is a sample.
B
C
E
D
A
F
G
H
13
Infrastructure Mode Configuration