Sending Documents via LAN
130
Internet Fax Ledger Size Document Transmission
To send with reduction, follow the steps below.
Repeat steps 1 to 5, except in step 4, set the "Ledger Email Transmit" setting to "OFF" position.
When the Select Mode "Ledger Email Transmit" setting is set to the "OFF" position, the transmission
reduction is according to the setting of Fax Parameter No. 141 (LAN XMT Reduction). (See the Table
below)
NOTE
1. Factory default setting for Fax Parameter No. 141 (LAN XMT Reduction) is "Invalid".
4
Make sure that the setting is and press .
Dial by any combination of the following methods:
• Manual Email Addressing, press after each station is entered. (Up to
70 stations)
• Address Book Email Addressing.
(Up to 200 stations, plus an additional 800 with the optional Hard Disk
Drive (DA-HD60) installed)
5
The document(s) is stored into memory with a file number.
The machine then connects to the LAN and transmits the Ledger size
document(s).
(After the document(s) are sent, the "Ledger Email Transmit" Select Mode will
automatically return to the preset position (ON))
Ledger Email Transmit = ON
:
Transmits actual document size (without reduction).
Ledger Email Transmit = OFF
:
Reduces LEDGER size document to B4 size or to A4/Letter
before transmission. (According to the Fax Parameter No. 141
(LAN XMT Reduction) setting, see Table below)
Document Size
Document Size Transmission
Ledger Email Transmit = ON
Ledger Email Transmit = OFF
Fax Parameter No. 141
(LAN XMT Reduction)
set to "Invalid"
Fax Parameter No. 141
(LAN XMT Reduction)
set to "Valid"
LEDGER LEDGER B4 A4/Letter
B4 B4 B4 A4/Letter
A4/Letter A4/Letter A4/Letter A4/Letter
ON
OK
OK
Memory Transmit STN(s):001
TO: PANASONIC
abc@panasonic.com
PANASONIC
QUALITY DEPT
ti4.fm 130 ページ 2002年8月20日 火曜日 午前9時54分