Panasonic KX-TDA100 Network Router User Manual


 
3.2 Connection
214 Installation Manual
External Modem Connection
After connecting the Hybrid IP-PBX and the external modem, set the power switch of the external modem
to "ON", then the external modem will be initialised with the default values.
The following AT command settings may be required for the modem:
The Data Terminal Ready (DTR) signal should be ignored.
The Data Terminal Equipment (DTE)/Modem flow control should be turned off.
Data compression should be disabled.
Error Correction is not necessary.
Notes
Use an RS-232C straight cable for connection between the Hybrid IP-PBX and external modem.
An AT command (for initialisation, enabling automatic answer, etc.) can only be programmed by
KX-TDA Maintenance Console. "AT&F0Q0E0V1S0=1X0&D0" is stored as the default value.
For more information about the AT command, refer to the external modem's instructions.
To RS-232C port (25-pin)
RS-232C Port
(9-pin)
To trunk/Hybrid IP-PBX extension
port assigned as the trunk destination
Modem
External Modem Hybrid IP-PBX
Signal Name Pin No. Signal Name
SD (TXD) 2
RD (RXD) 3
DR (DSR) 6
ER (DTR) 20
2 RD (RXD)
3 SD (TXD)
4 ER (DTR)
6 DR (DSR)
Pin No.