Panasonic KX-TDA100 Network Router User Manual


 
2.4 Information about the Trunk Cards
90 Installation Manual
2.4.8 BRI4 Card (KX-TDA0284) and BRI8 Card (KX-TDA0288)
Function
Accessories and User-supplied Items
Accessories (included): Ferrite core(s) × 1 (BRI4 card) or 2 (BRI8 card)
User-supplied (not included): RJ45 connector
Notes
LINE 5 to LINE 8 are for BRI8 card only.
When connecting these optional service cards to the trunk, connect through an NT1; do not
connect to the U interface of the trunk directly.
These optional service cards have 100 of terminal resistance. For use in point to multi-point
connection, the cards must be placed at the end of the bus.
When connecting the RJ45 connector, attach the included ferrite core. Refer to "2.2.9 Attaching a
Ferrite Core".
These optional service cards can be used for either trunk or extension connection, by setting the
A/B switch or using the connector with appropriate pin assignments.
For details about power failure transfer, refer to "2.12.1 Power Failure Connections".
To confirm the trunk connection, refer to "Confirming the Trunk Connection" in "2.13.1 Starting the
Hybrid IP-PBX".
Notice
If the connected ISDN terminal has no external power source, make sure that the power is supplied
from the BRI4/BRI8 card by programming the Hybrid IP-PBX accordingly.
However, if there is an external power source to the terminal, make sure that there is no power supplied
to the terminal from the BRI4/BRI8 card. Failure to do so may cause damage to the power supply circuit
of the BRI4/BRI8 card or the terminal.
BRI4: 4-port ISDN Basic Rate Interface card with 1 power failure transfer port. EURO-ISDN/ETSI
compliant.
BRI8: 8-port ISDN Basic Rate Interface card with 1 power failure transfer port. EURO-ISDN/ETSI
compliant.
LEDs
RJ45
(LINE 1 to LINE 8)
AB
To NT1/
Extension