Panasonic KX-HGW200 Network Card User Manual


 
16
Setup
3
Connect the computer to the wall mounted single-line telephone jack.
For more detailed information, refer to the HomePNA card manual.
4
If you are thinking of attaching a telephone to the KX-HGW200, follow
the steps below (a, b and c). If not, skip these steps.
a: Connect the end of the telephone line cord to the PHONE jack on
the KX-HGW200.
b: Connect the other end of the telephone line cord to the single-line
telephone jack of the telephone.
c: Make sure a dial tone is heard from the handset of the telephone.
To connect computers using optional wireless cards:
An optional Panasonic wireless card, model KX-HGC200, is required for the
KX-HGW200 and for each computer in the network.
Before you insert the wireless card into the KX-HGW200, turn off the
KX-HGW200 by removing the AC adaptor.
Install a Panasonic wireless card in the wireless card slot of the
KX-HGW200 and in the appropriate PCMCIA slot of the computer(s). The
driver software that comes with the optional wireless card must be
installed in the computer.
To install the optional Panasonic wireless card KX-HGC200 and the driver
software in either the KX-HGW200 or a computer, refer to the operating
instructions that come with the wireless card.
The KX-HGW200 is compatible with the optional Panasonic wireless card
KX-HGC200 only. Do not insert any other PCMCIA card into the
KX-HGW200.
Telephone
PHONE jack
Telephone line
cord
PHONE
PQQX12817ZA \1-P29 01.3.8 3:17 PM y[W 16