Filter
Top Products
18
“
Setup
To connect an Ethernet Hub to the KX-HGW200:
If you are not currently using an Ethernet hub to network more than one
computer, please skip this page.
1
Make sure the computers and other devices connected to the Ethernet
Hub are turned off.
2
Set the HUB/PC switch of the KX-HGW200 to HUB.
3
Connect the category 5 straight cable to
TO COMPUTER/ETHERNET HUB port of the KX-HGW200.
4
Connect the other end of the category 5 straight cable to the LAN port
of the Ethernet Hub.
HUB/PC switch
HUB PC
To RJ-45 jack
on the cable/
xDSL modem
TO COMPUTER/
ETHERNET HUB port
Category 5
straight cable
Ethernet Hub
LAN port
Note:
Do not connect the category 5 straight cable to the UPLINK port of the
Ethernet Hub.
Note:
If using an Ethernet connection, an Ethernet card and software have
to be installed properly on the computer first.
PQQX12817ZA \1-P29 01.3.8 3:17 PM y[W 18