Filter
Top Products
Troubleshooting
IIIII I IIIIIIIIII ii iiiiiiiiiiiiiiiiiiiiii
If You Have Any of These Problems
Mode Symptom Action page
iiiiii ================== i iiiiiii i
During Installation The display is blinking Battery discharged completely. This may happen at first 25
installation, After setting the clock, the blinking will Stop,
...................... _1 Checkthat your document is.....
Document doesn't . ir_eeof staples and paper
ifeed/multiple feed clips, and that it is not greasy or torn,
2. Check that your document isthe right type to send through 39
a fax machine by consulting the list on "Documents You
Cannot Send". ifyour document has the characteristics
ILsted, make a photocopy of your document and send the
copy instead.
3. Check that the document is loaded properly. 40
4. Adjust the ADF Pressure Plate. 162
Document jam The information code 031 will appear on the display if the 159
document becomes jammed.
Does not stamp 1. Check ifStamp LED islit. 42
2, Check Fax parameter No, 04 and No. 28 settings, 35,36
During Transmission
Transmission Copy
Quality
During Reoeption
Stamp too light
Vertical lines on the
transmitted document
Transmitteddocument
*sblank
i ,,,,,,,,,
No recording paper
Recording paper jam
Recordingpaper
doesn't advanceinto
machine
Replace stamp or refill ink. 163
Check own copy quality. If copy is OK, your machine has no 160
_roblem, report to receiving party that they have a problem. If
copy is NG, clean the Document Scanning Area,
1. Make sure the document is set face down. 160
2. Check own copy quality, tt copy is OK, your machine has no
problem, report to receiving party that they have a problem.
Ifcopy is NG, clean the Document Scanning Area.
The information code 010 will appear on the display if the paper ' 18
runs out,
The informationcode 001,002 or 003 willappear onthe display 158
ifthe paper gets jammed,
Make sure that there ispaper in the Paper Cassette. Follow 18
the instructionsfor loading paper,
Recording paper
doesn't eject after
printing
Recording papers are
not stacked in
sequence. Machine
does not print from the
last page received.
Document auto
reduction doesn't work
Out of toner
Check to see if the recording paper is jammed inside of the 158
machine.
1. Check if Fax Parameter No. 65 isset to valid. 38
2. If memory becomes full during reception, the machine will 170
startto printfrom the f st page received. We recommend that
optional memory is installed if this symptom occurs
frequently.
Check Print Reduction settings. 61
The information code 041 willappear on the display ifthe Toner
Cartridge runs out of toner.
16
153