Filter
Top Products
Before You Start
6
To avoid machine malfunction, do not use the equipment under the following conditions:
■ Static Electricity Damage
To prevent static electricity damage to any of the following components, touch a grounded metal surface, such as the
printer's bare metal frame prior to touching the component.
• Interface connectors: parallel, USB, network, and connector for optional paper feeder
• Connector pins on the optional paper feeder
• Electrical components, connectors inside the printer
■ Interface Cable
Always use a shielded interface cable. Use of an unshielded cable can result in radio interference with data.
■ Power Source
The voltage level of the power source must not vary more than ±10% from the voltage level marked on the nameplate
(located on the rear of the unit).
Do not use an extension cord.
Do not use a line conditioner, transient suppressor or surge protector as it may cause a machine error.
■ Ventilation Space
The ventilation space is needed more than 20 mm (0.8") between the printer and a wall.
Cautions
Not genuine toner
• Direct exposure to sunlight.
• Extremely high or low
temperature [temperature
range: 10°C to 32.5°C (50°F
to 90.5°F)]
• Extremely high or low
humidity. (humidity range:
15% to 80% RH)
• Condensation due to rapid
change of temperature.
• Areas of poor ventilation.
• Areas of high dust or
chemical fume concentration.
(solvent etc.)
• Unstable or unlevel surfaces.
• A very large stack of media
into the manual feed.
• Directly in front of air
conditioning vents.
• Liquids near the equipment.
• Any toner other than genuine
Panasonic toner; it may
damage the printer.
Media for ink jet (paper,
transparency, etc.)
Before You Start