Filter
Top Products
Operating the Main Menu
Configuration the Main Menu (AV Input)
For computer inputs, see the following page.
You can adjust video quality (PICTURE), audio quality (SOUND), etc. using the menus.
The menus are configured as follows:
Main menu (AV inputs : During AV IN input signal)
PIXEL CLOCK TRACKING
PHASE
POSITION
V. POS.
The vertical position of the video image being projected is adjusted.
H. POS.
The horizontal position of the video image being projected is adjusted.
PICTURE
BRIGHTNESS
CONTRAST
SHARPNESS
COLOR
TINT
ALL RESET
SOUND
TREBLE
BASS
OPTIONS
MENU AUTO OFF
LINE DISPLAY
RIGHT LEFT REV.
TOP BOTTOM INV.
CLAMP
RESIZE
BACK COLOR
COLOR TEMP.
Normally, no adjustment is required. The lateral size and display area of video image are adjusted.
Normally, no adjustment is required. Flickering or dim video image is adjusted.
The brightness of the video image being projected is adjusted.
The contrast of the video image being projected is adjusted.
The sharpness of the video image being projected is adjusted.
The color density of the video image being projected is adjusted.
The tint of the video image being projected is adjusted. (Displayed only for NTSC signal)
All the items adjusted are reset.
The treble of the audio sound being input is adjusted.
The bass of the audio sound being input is adjusted.
Sets whether to turn off menu display automatically (YES) or not (NO).
Sets whether to make the line display effective (ON) or not (OFF) for about 5 seconds after input
switching.
Video image is reversed right-to-left (for upside-down hanging (ceiling)).
Video image is inverted top-to-bottom (for upside-down hanging (ceiling)).
Sets the clamp pulse’s position at the back porch (BP) or on the sink tip (ST). Normally, the clamp
pulse is used at BP If, with some PCs or workstations, the screen becomes unstable such as
being too dark or too bright, try to switch to ST.
Does not work with AV (video) input. (RESIZE is shown in gray.)
Specifies the background color when there is no video signal. Background color can be selected
from BLUE, CYAN, BLACK, GREEN, MAGENTA, RED, and YELLOW.
Adjusts the color temperature of the image being projected. Make adjustment when the image
becomes reddish or bluish.
Color temperature can be set to LOW, MIDDLE, or HIGH.
ASPECT CHANGE
: Selects the vertical-to-horizontal ratio of the image projected. The factory-set ratio is 4 : 3. When
projecting high-vision video image, a ratio of 16 : 9 can be selected.
SLEEP TIME
: Sets the sleep time.
After an input signal is no longer detected. The projector goes into a stand-by state. The stand-by
state is not entered immediately. It takes time (the sleep time). This time is selectable : 10, 20, 30,
60 minutes.
LAMP TIME
: Indicates the accumulated used hours of the light-source lamp.
SOURCE
: Normally used in AUTO. If use in AUTO is unstable such as color not appearing, the screen image is disturbed or
intermitted, then set to the dedicated source (forced mode) in accordance with the input signal.
DECODER
: Normally, set to AUTO. The color system of an input signal is automatically identified and shown in (
). When use
in AUTO is unstable such as no color being shown, set the dedicated color system in accordance with the input
signal. You can select from AUTO, NTSC, NTSC4.43, PAL, and SECAM.
LANGUAGE
: Text on the screen can be changed to a language other than English. Languages that can be displayed are the
following six :
(Japanese), ENGLISH, DEUTSCH (German), ESPAÑOL (Spanish), ITALIANO (Italian), and
FRANÇAIS (French). However, some text such as “QUICK ALIGNMENT”, etc. are shown only in English.
34