Filter
Top Products
[ADVANCED MENU]
ENGLISH - 53
Settings
8) Press ◀▶ to switch [ON].
z
A marker for image position adjustment is
displayed. The green line is the start point of
edge blending adjusted with [START] in Step
6). The red line is the edge blending end point
adjusted with [WIDTH] in Step 6).The position
where the red and green lines overlap for the
sets to join will be the optimal point.
Make sure to set the correction width for the
sets to join as the same value. Optimal joining
is not possible with the sets with different
correction widths.
The optimal point is where these lines overlap.
Green line
Red line
9) Press ▲▼ to select [GAMMA].
10) Press ◀▶ to switch [GAMMA].
z
The setting will change as follows each time
you press the button.
[2.2] [1.8] [2.0]
11) Press ▲▼ to select [BRIGHT
ADJUST].
12) Press the <ENTER> button.
z
The [BRIGHT ADJUST] screen is displayed.
13) Press ▲▼ to select [BRIGHT INSIDE].
14) Press the <ENTER> button.
z
The [BRIGHT INSIDE] individual adjustment
screen is displayed.
z
When [INTERLOCKED] is set to [OFF], [RED],
[GREEN], and [BLUE] can be adjusted.
15) Press ▲▼ to select an item, and
press ◀▶ to adjust the setting.
z
Once the adjustment is completed, press the
<MENU> button to return to the [BRIGHT
ADJUST] screen.
16) Press ▲▼ to select [UPPER],
[LOWER], [LEFT], or [RIGHT] from
[OUTSIDE AREA].
17) Press ◀▶ to set the area (width)
where [BRIGHT INSIDE] is adjusted.
18) Press ▲▼ to select [BRIGHT
OUTSIDE].
19) Press the <ENTER> button.
z
The [BRIGHT OUTSIDE] individual adjustment
screen is displayed.
z
When [INTERLOCKED] is set to [OFF], [RED],
[GREEN], and [BLUE] can be adjusted.
20) Press ▲▼ to select an item, and
press ◀▶ to adjust the setting.
[OUTSIDE AREA] (right)
Projection range
Edge blending [WIDTH] (right)
[MARKER] (red)
Edge blending [START] (right)
([MARKER] (green))
[BRIGHT OUTSIDE]
[BRIGHT INSIDE]
Note
z
[BRIGHT ADJUST] is a function to make hard
to notice the black level of the part of the image
overlapping getting brighter when multiple screens
are set using [EDGE BLENDING]. The optimal
point of the correction is set by adjusting the
[BRIGHT INSIDE] so the black level of the image
overlapping area will become the same level as
the non-overlapping area. If the bordering part of
t
he part where the image is overlapping and the
non-overlapping part gets brighter after adjusting
[BRIGHT INSIDE], adjust the width of the top,
bottom, left, or right. When only the bordering part
became brighter by the width adjustment, adjust
[BRIGHT OUTSIDE].
z
The joining part may look discontinuous depending
on the position you are looking from when a screen
with high gain or rear screen is used.
[RASTER POSITION]
This will allow the position of the image to move within
the display area arbitrarily when the input image is not
using the whole display area.
1) Press ▲▼ to select [RASTER
POSITION].
2) Press the <ENTER> button.
z
The [RASTER POSITION] screen is displayed.
3) Press ▲▼◀▶ to adjust the position.