Filter
Top Products
Powering ON/OFF
ENGLISH - 35
Basic Operation
Powering off the projector
1) Press the STANDBY < > button.
2) Press the ◀▶ buttons to select [OK],
and press the <ENTER> button.
(Or press the STANDBY <
> button
again.)
z
Projection of the image will stop, and the Power
indicator <STANDBY (RED)/ON (GREEN)> on
the projector lights in orange.
(The fan keeps running.)
3) Wait until the power indicator
<STANDBY (RED)/ON (GREEN)> of
the projector turns red (until the fan
stops).
4) Press the <OFF> side of the <MAIN
POWER> switch to turn off the power.
Note
z
Do not turn on the power immediately after
turning it off.
I
n the cooling state of the luminous lamp after the
power is turned off, the lamp may not light up even
if the power is turned on. To light up the lamp, turn
on the power again after the luminous lamp goes
into standby status. Turning on the power while the
lamp is still hot may shorten the lamp life.
z
The projector consumes approximately 9 W
power when the power is turned off by the
remote control with the main power of the
projector turned on.
(When [STANDBY MODE] is set to [NORMAL])
If [STANDBY MODE] (
page 63) is set to [ECO],
the power consumption in the standby mode can
be reduced.
Direct power off function
Even if you turn the <MAIN POWER> switch [OFF]
during projection or just after the lamp turns off, the
cooling fan will continue to rotate using internally
stored power. In cases where the <MAIN POWER>
switch is not easily accessible, such as during ceiling
mount, you can safely turn off the power by using
the power breaker switch. This function also works
if a power outage occurs or if the power cable is
accidentally disconnected from the outlet right after
turning off the power.
Note
z
If projection was stopped by turning off the power
breaker switch and you turn on the power breaker
again, the power indicator <STANDBY (RED)/ON
(GREEN)> will light in green and projection will
start again.
z
When the lamp has been cooled by the direct
power off function, it sometimes takes longer than
u
sual for the lamp to light up again.
z
Conrm that the fan has stopped before packing
the projector to transport or store.
STANDBY(RED)/
ON(GREEN)
LAMP TEMP
FILTER
1)
1)3)
2)
2)4)