Filter
Top Products
Start-up display
18 - ENGLISH
Preparation
Start-up display
The initial setting screen is displayed when the projector is switched on for the rst time after purchase as well as
when [INITIALIZE] – [ALL USER DATA] (
page 74) is executed. Set them in accordance with circumstances.
In other occasions, you can change the settings by menu operations.
Note
z
When the projector is used for the rst time, you may be required to adjust the focus, zoom, and shift to display
the menu screen clearly.
Refer to “Adjusting the focus, zoom, and shift” (
page 39) for details.
■
Initial setting (display language)
Select the language to show on the screen.(
page 57)
1) Press
to select the display
language.
(17(5
,1,7,$/6(77,1*
3/($6(6(/(&7/$1*8$*(
6(/(&7
6(7
2) Press the <ENTER> button to proceed
to the initial setting.
■
Initial setting (projector setup)
Set each item.
1) Press
to select an item.
2) Press
to switch the setting.
ENTER
16㧦10
SWITCH TO HIGH ALTITUDE MODE "ON"
IF OVER 1400m (4593Ft).
MENU SELECT CHANGE
SET
INITIAL SETTING
PROJECTION METHOD
COOLING CONDITION
SCREEN FORMAT
SCREEN POSITION
HIGH ALTITUDE MODE
FRONT/FLOOR
FLOOR SETTING
OFF
Refer to the following page for details of each
item.
z
[PROJECTION METHOD] (
page 66)
z
[COOLING CONDITION] (
page 67)
z
[SCREEN FORMAT] (
page 60)
z
[SCREEN POSITION] (
page 60)
z
[HIGH ALTITUDE MODE] (
page 67)
3) Press the <ENTER> button.
z
Conrm the setting value to complete the initial
setting.
Note
z
If you press the <MENU> button in the initial setting
(projector setup) screen, you can go back to the
initial setting (display language) screen.