Filter
Top Products
[POSITION] menu
ENGLISH - 53
Settings
3) Press
to select [INTERLOCKED].
4) Press
to switch [INTERLOCKED].
[OFF]
Set the [VERTICAL] and
[HORIZONTAL] zoom ratio.
[ON]
Use [BOTH] to set zoom ratio.
Horizontal and vertical can be
expanded by units of 1.0 time.
Note
z
When [ASPECT] is set to [THROUGH], [ZOOM] is
not displayed.
z
When anything but [MODE] is selected for
[DEFAULT], [ASPECT] is not displayed.
[CLOCK PHASE]
You can adjust to achieve an optimal image when
there is a ickering image or smeared outlines.
1) Press
to select [CLOCK PHASE].
2) Press
or the <ENTER> button.
z
The [CLOCK PHASE] individual adjustment
screen is displayed.
3) Press
to adjust.
z
Adjustment value will change between 0 and
31. Adjust so that the amount of interference is
at a minimum.
Note
z
Optimal value may not be achieved if the output
from the input computer is unstable.
z
Optimal value may not be achieved when there is a
shift in the total dot numbers.
z
[CLOCK PHASE] can be adjusted only when a
signal is input to the <RGB 1 IN> terminal or the
<RGB 2 IN> terminal.
z
[CLOCK PHASE] cannot be adjusted when a digital
signal is input.
z
If you press
while the adjustment value is [31],
the value will become [0]. If you press
while the
adjustment value is [0], the value will become [31].
[KEYSTONE]
You can correct the trapezoidal distortion that occurs
when the projector is installed tilted or when the
screen is tilted.
1) Press
to select [KEYSTONE].
2) Press the <ENTER> button.
3) Press
to select the item to adjust.
4) Press
to adjust the level.
■
[KEYSTONE]
■
[SUB KEYSTONE]
■
[LINEARITY]
Note
z
The menu or logo may run off the screen
when various adjustments are performed with
[KEYSTONE].
z
Various adjustments with [KEYSTONE] are
possible to correct up to ±40° for the tilt in vertical
direction. However, the picture quality will degrade
and it will get harder to focus with more correction.
Install the projector so the correction will be as
small as possible. (±30° when using xed-focus
lens (ET-DLE055), or super short focus zoom lens
(ET-DLE080))
z
Image size will also change when [KEYSTONE] is
used to perform adjustments.
z
Trapezoidal distortion may occur depending on the
lens shift position.
z
Aspect ratio of the image size may shift depending
on the correction or lens zoom value.