Filter
Top Products
Chapter 3 Basic Operations — Switching on/off the projector
ENGLISH - 33
Indicator status Status
Off The main power is switched off.
Red
Flashing
The power is switched off (in standby mode). [STANDBY MODE] is set to [NORMAL].
Projection will start when the power <
v
/
b
> button is pressed.
f
The projector may not operate when the temperature indicator <TEMP> is ashing.
(
x
page 109)
Lit
The power is switched off (in standby mode). [STANDBY MODE] is set to [ECO].
Projection will start when the power <
v
/
b
> button is pressed.
f
The projector may not operate when the temperature indicator <TEMP> is ashing.
(
x
page 109)
Green Lit Projecting.
Note
f
The projector consumes power even in standby mode (the power indicator <ON (G)/STANDBY (R)> lights/ashes in red).
Refer to “Power consumption” (
x
page 123) for the power consumption.
f
The power indicator <ON (G)/STANDBY (R)> ashes in green if a remote control signal is received.
f
The power indicator <ON (G)/STANDBY (R)> ashes in green slowly when the projector is in AV mute mode.
Switching on the projector
1)
3)
2)
3)
1)
Connect the power plug to an outlet.
f
(AC 100 V - 240 V 50 Hz/60 Hz)
2)
Press the <ON> side of the <MAIN POWER> switch to turn on the power.
f
The power indicator <ON (G)/STANDBY (R)> lights/ashes in red, and the projector enters the standby mode.
3)
Press the power <v/b> button.
f
The power indicator <ON (G)/STANDBY (R)> lights in green and the image is soon projected on the screen.
Note
f
If the projector is switched on at around 0 °C (32 °F), a warm-up period of approximately ve minutes may be necessary until an image is
displayed.
The temperature indicator <TEMP> lights during the warm-up period. When the warm-up is completed, the temperature indicator <TEMP>
turns off and the projection starts. Refer to “Managing the indicated problems” (
x
page 109) for the indicator status.
f
If the operating environment temperature is low and warm-up takes more than ve minutes, the projector will judge that a problem has
occurred and the power will automatically be set to standby mode. If this happens, increase the operating environment temperature to 0 °C
(32 °F) or higher, turn off the main power, and then turn on the power again.
f
If the [PROJECTOR SETUP] menu
→
[ECO MANAGEMENT]
→
[STANDBY MODE] (
x
page 71) is set to [ECO], there may be a delay in
displaying when the power is turned on compared to when the setting is [NORMAL].
f
When the power is turned or an input signal is switched, you may here a high-frequency driving sound. This is not a malfunction.
f
If the [PROJECTOR SETUP] menu → [INITIAL STARTUP] (
x
page 74) is set to [LAST MEMORY] and the power is turned off by pressing
the <OFF> side of the <MAIN POWER> switch or by using the breaker directly while projecting at the last time of use, the power indicator
<ON (G)/STANDBY (R)> lights in green and projection starts after a while when the power is turned on by pressing the <ON> side of the
<MAIN POWER> switch with the power plug connected to the outlet, or when the breaker is turned on.