Filter
Top Products
Chapter 4 Settings — [NETWORK] menu
ENGLISH - 99
[E-mail set up] page
When there is a problem, an email can be sent to preset email addresses (up to two addresses).
Click [Detailed set up]
→
[E-mail set up].
1
2
3
4
5
6
1 [ENABLE]
Select [Enable] to use the E-mail function.
2 [SMTP SERVER NAME]
Enter the IP address or the server name of the E-mail server
(SMTP). To enter the server name, the setup of the DNS server
is required.
3 [MAIL FROM]
Enter the E-mail address of the projector. (Up to 63 characters
in single byte)
4 [MEMO]
Enter information such as the location of the projector that
noties the sender of the E-mail. (Up to 63 characters in single
byte)
5 [MINIMUM TIME]
Change the minimum interval for the temperature warning mail.
The default value is 60 minutes. In this case, another E-mail
will not be sent for 60 minutes after sending the temperature
warning mail even if it reaches the warning temperature.
6 [INTAKE AIR TEMPERATURE]
Change the temperature setting for the temperature warning
mail. A temperature warning mail is sent when the temperature
exceeds this value.
8
7
7 [E-MAIL ADDRESS 1]
Enter the E-mail address to be sent.
8 Settings of the conditions to send E-mail
Select the conditions to send E-mail.
[MAIL CONTENTS]:
Select either [NORMAL] or [SIMPLE].
[ERROR]:
An E-mail message is sent when an error occurred in the self-
diagnosis.
[INTAKE AIR TEMPERATURE]:
An E-mail message is sent when the air intake temperature has
reached the value set at the above eld.
[PERIODIC REPORT]:
Place a check mark on this when E-mail is to be sent
periodically.
It will be sent on the days and time with the check mark.