Filter
Top Products
36
24 PRINT REDUCTION 1 Fixed Selecting print reduction mode.
Fixed: Reduce received document according to setting of
Parameter No. 25.
Auto: Reduce received document according to the length of
received documents.
*2 Auto
25 REDUCTION RATIO 70 70% Selecting fixed print reduction ratio from 70% to 100%. This
parameter functions only when fixed print reduction is selected on
Fax Parameter No. 24.
---- ----
100 100%
26 POLLING PASSWORD (----) Setting a 4-digit password for secured polling. (See page 68)
27 POLLED FILE SAVE *1 Invalid Selecting whether the machine retains the polled document in
memory even after the document is polled once.
2Valid
28 STAMP AT MEM. XMT 1 Invalid Selecting whether the machine stamps the original documents
when storing the documents into memory.
(depending on the Stamp setting on the Control Panel)
*2 Valid
31 INCOMPLETE FILE
SAVE
*1 Invalid Selecting whether the machine retains the document in memory if
the document is not successfully transmitted.
2Valid
32 COPY REDUCTION 1 Manual Selecting whether the machine performs the copy reduction ratio
automatically or manually.
Manual : The machine will prompt you for the Zoom ratio (100% to
70%) when making copies.
Auto : The machine will automatically determine the reduction
ratio according to the length of the original document.
*2 Auto
33 XMT REDUCTION 1 Invalid Selecting whether the machine performs reduction when the
transmitting document is wider than the recording paper used at
the receiving machine.
*2 Valid
34 ENERGY SAVER MODE
1 Off
To reduce the power consumption in standby, select either Energy-
Saver or Sleep mode and specify the Delay Time (1 to 120
minutes) for the machine to enter into the selected mode.
The Delay Timer setting is only available in the Energy-Saver or
Sleep Modes.
Off : The unit will remain in standby mode and
consume more energy than when in Energy-
Saver or Sleep modes.
Energy-Saver Mode: Saves energy by consuming less power than
when in standby mode by turning off the fuser
unit after the specified time.
Sleep Mode: This is the lowest power state that the
machine enters after the specified time
without actually turning off. (Sleep Mode is
not available when the optional Parallel Port
Interface Kit, PDL Printer Driver Kit or G3
Communication Port Kit is installed)
2Energy-Saver
*3 Sleep
Continued on the next page.
No. Parameter
Setting
Number
Setting Comments
Customizing Your Machine