Filter
Top Products
SDCP Menus
3-293821-A2-GB20-30 February 1998
Table 3-5
(5 of 5)
DTE Dialer Configuration Options
V25bis IdleFill: Mark
Nxt Mark Flag
V.25bis Idle Fill. Determines whether a mark or flag is used as an idle fill character for the DTE. The modem responds to
the DTE using the same idle fill.
NOTE: This configuration option only appears if DTE Dialer is configured for V.25bis HDLC or V25bis Bisync.
The factory default is Mark.
AT command equivalent is S-register S63=
n.
V.25b NewLineChr: CR+LF
Nxt CR+LF CR LF
V.25bis New Line Character. Sets the modem for the command line terminator used by the DTE in V.25bis Async mode.
The modem responds to the DTE using the same line terminator.
NOTE: This configuration option only appears if DTE Dialer is configured for V25bis Async.
The factory default is CR+LF.
AT command equivalent is S-register S64=
n.