Filter
Top Products
2-1
8700-A2-GB20-00
April 2000
Using the Asynchronous Terminal
Interface
2
User Interface Access
You can communicate with the asynchronous terminal interface (ATI) using one
of the following methods:
H Direct connection through the Management Serial port of the DSLAM (locally
or via an external modem).
H Telnet session using a Network Management System (NMS) connected to a
LAN/WAN port on the DSLAM.
H Telnet session through the Embedded Operations Channel (EOC).
NOTE:
Only one asynchronous terminal interface session can be active at a time,
and another user’s session cannot be forced to end. To automatically log out
a user due to inactivity, enable the Inactivity Timeout option (see Table A-11,
Telnet Session Options, in Appendix A, Configuration Options).
Security can limit ATI access several ways. To set up security or a login ID, refer
to Chapter 6, Security.
Management Serial Port Settings
Ensure that the device you connect communicates using these settings:
H Data rate set to 9.6 kbps.
H Character length set to 8.
H Parity set to None.
H Stop Bits set to 1.
Refer to the installation document for your DSLAM.