Filter
Top Products
Installing the Unit
2-2
7924-A2-GB20-30
October 1997
Connecting to the Network
" Procedure
1. Connect one end of the supplied 14′ twisted-pair network cable into the rear
panel HDSL jack. Connect the other end to your HDSL network interface.
NOTE:
Do
not
use a flat VF network cable, as this may severely degrade the
performance of the termination unit. Use only a twisted-pair network
cable.
2. Connect a V.35 or DSX-1 interface cable into the appropriate connector on
the rear panel. Connect the other end to your V.35 or DSX-1 equipment.
HotWire 7924 V.35-compatible units are not designed to be used at both ends of
an HDSL connection.
Connecting Power to the Unit
HDSL DS1
48 VDC
97-15356-01
DSX-1-Compatible HotWire 7924 – Rear Panel
HDSL
V.35
48 VDC
97-15264
V.35-Compatible HotWire 7924 – Rear Panel
Plug the power transformer into the appropriate (115 or 230 Vac) power outlet.
Connect the power lead into the –48 Vdc jack on the rear panel.
To obtain information on the power supplies and power cord adapters available,
refer to
Warranty, Sales, and Service Information
on page A at the beginning of
this User’s Guide.