Filter
Top Products
1.3.4 Slide the Management Module Firmly into the Chassis
Tighten the fastening screws on the management module faceplate by turning
them clockwise with a Phillips screwdriver. Be careful NOT TO OVER-TIGHTEN the
screws.
1.4 Install Your Interface Module(s)
Interface modules provide the subscriber connections for an IPD4000E; up to four [4]
interface modules may be installed in the IPD4000E (slots 1-4). There are a variety of
models available for purchase; visit http://www.nettonet.com/products
for a list of
available products or contact your Net to Net sales representative for further
information. Any combination of interface module models may be installed in an
IPD4000E as long as they are supported by the model type and version number of your
management module; refer to the Release Notes for your particular management
module model at http://www.nettonet.com/support/docs for compatibility
information.
1.4.1 Select a Slot for Installation
Although the IPD4000E is factory shipped with Slot 1 open, interface modules
may be installed in any slot, 1-4.
MANAGEMENT MODULE
Slot Module Guides
Fastening Screws
Page 6 of 17IPD4000E Installation Instructions 220-0000097 rev01