Filter
Top Products
1
TABLE OF CONTENTS
Section
Page
1.0 General Information...............................................................2
1.1 Warranty Statement
1.2 CE Notice
1.3 Radio and TV Interference
1.4 FCC Information
1.4.1 FCC Compliance
1.5 Industry Canada Notice
1.6 Service Information
2.0 General Information...............................................................6
2.1 Features
2.2 General Product Description
2.3 Supported Applications
2.3.1 The 2710 as the Interface Between the Telco and CPE
2.3.2 The 2170 as High-Speed Short Range Modem
3.0 Configuration .........................................................................8
3.1 DIP Switch Configuration
3.2 Software Configuration
3.2.1 Introduction to Main Menu
3.2.2 System Configuration
3.2.3 Systems Diagnostics
3.2.4 Unit Options
4.0 Installation ..........................................................................31
4.1 DTE Interface Connection
4.2 Network Interface Connection
4.3 Power Connection
4.3.1 Using the AC Power Supply (120VAC or 100-240VAC)
4.3.2 Supplying DC Power
4.3.3 Supplying Power via Pin KK
5.0 Operation.............................................................................33
5.1 LED Descriptions
5.2 Loop (V.54 & Telco) Diagnostics
5.2.1 Operating Local Loopback (LL)
5.2.2 Operating Remote Digital Loopback (RL)
5.2.3 Central Office Loops
5.3 Bit Error Rate (V.52) Diagnostics
Appendix A - Specifications ........................................................38
Appendix B - Cable Recommendations......................................39
Appendix C - Factory Replacement Parts and Accessories ......40
Appendix D - Interface Pin Assignments ....................................41
Appendix E - Power Supply Interface ........................................43
2
1.0 GENERAL INFORMATION
Thank you for your purchase of this Patton Electronics product.
This product has been thoroughly inspected and tested and is warrant-
ed for One Year parts and labor. If any questions or problems arise
during installation or use of this product, please do not hesitate to con-
tact Patton Electronics Technical Services at (301) 975-1007.
1.1 WARRANTY STATEMENT
Patton Electronics
warrants all Model 2710 Series components
to be free from defects, and will—at our option—repair or replace the
product should it fail within one year from the first date of
shipment.This warranty is limited to defects in workmanship or materi-
als, and does not cover customer damage, abuse, or unauthorized
modification. This product contains no serviceable parts; therefore the
user shall not attempt to modify the unit in any way. If this product fails
or does not perform as warranted, your sole recourse shall be repair or
replacement as described above. Under no condition shall Patton
Electronics be liable for any damages incurred by the use of this
product. These damages include, but are not limited to, the following:
lost profits, lost savings and incidental or consequential damages aris-
ing from the use of or inability to use this product. Patton Electronics
specifically disclaims all other warranties, expressed or implied, and
the installation or use of this product shall be deemed an acceptance
of these terms by the user. In the event the user detects intermittent or
continuous product malfunction due to nearby high power transmitting
radio frequency equipment, the user is strongly advised to use only
data cables with an external outer shield bonded to a metal or metal-
ized connector.
1.2 CE NOTICE
The CE symbol on your Patton Electronics equipment indicates
that it is in compliance with the Electromagnetic Compatibility (EMC)
directive and the Low Voltage Directive (LVD) of the Union European
(EU). A Certificate of Compliance is available by contacting Patton
Technical Support.
WARNING! This device is not intended to be con-
nected to the public telephone network in Europe.