Copyright © 2006
Patton Electronics Company
All Rights Reserved
43
APPENDIX E
PATTON NETLINK-T1 MODEL 2710
POWER SUPPLY INTERFACE
Via Main 5VDC power jack (J1)
Center Pin: +5VDC @ 300 mA
Outer Barrel: Ground
Jumper Position for Power via DC Power Jack (default):
Via Auxiliary Power Supplied to Pin KK on V.35 connector
DC Power supplied to pin KK must be 5VDC ± 5%, 300mA minimum.
Jumper Position for Power via Pin KK:
NOTE: NetLink-T1™ is factory configured to accept power from
the enclosed DC wall adapter (See Sections 4.3.1 and 4.3.2
above). If you wish to supply power via pin KK on the interface,
you must change the setting of the
power supply jumper
on the
printed circuit board. All power sources must be SELV (Circuit,
Safety Extra Low Voltage) specified. (See CENELEC EN60950,
Section 1.2.8.5)