Filter
Top Products
13
4) When the unit is first turned on, the terminal screen may
appear blank. Press the <Enter> key. If your serial connection
is good, then the unit will immediately display a password
prompt. The following message will appear in the middle of
the screen:
5) Type in the password and press <Enter>. The factory default
password for the unit is:
patton
NOTE: If the entry is incorrect, the password screen will clear
and prompt you again for the correct password. The password
you enter will not be shown. For security, asterisks will be dis-
played for each letter you type. The maximum length of the
password, which can include any character the terminal can
generate, is 16 characters.
7) The NetLink-T1™ will then display the Main Menu screen.
Patton Electronics
Menu Management
Enter Password: _
14
3.2.1 Introduction to Main Menu
After entering the password, you may access all of the system’s
functions and parameters. The Main Menu looks like this:
HELPFUL HINTS
1. To make a selection, key the highlighted letter that corre-
sponds to a menu selection.
2. To execute the selection, type <Enter/CR>
3. Select g Save Changes from Main Menu after making modi-
fications to any NetLink-T1™ parameter. Otherwise, changes
will be lost when the NetLink-T1™ is turned off.
d