Filter
Top Products
4 • Customer Responsibility Users Manual Model 656/636
AC Power Line
PAXAR requires that the electric service be 10 Amps @ 110VAC or 10 Amps @
220VAC. This will allow the computer and any additional support or service
equipment to be plugged into the same service.
Any electrical service which is supplying a PAXAR printer or peripheral equipment
connected to a PAXAR printer should follow standard electrical code practices
including proper grounding and neutral requirements.
The PAXAR printer was designed to operate in an industrial setting for extended
period of time; however, the printer is controlled by a microprocessor which is very
sensitive to brownouts or power spikes. For this reason as well as the minimum
recommended current supply, PAXAR recommends that a separate “clean” service
be installed or reserved for the exclusive use of the PAXAR printer and it’s
peripherals.
Unpacking
The PAXAR printer is shipped in a large cardboard box which may be difficult to
move by hand.
DO NOT REMOVE THE PRINTER FROM THE CRATE OR UNPACK IN
THE SHIPPING / RECEIVING DEPARTMENT.
NOTE: Unpacking in the shipping/receiving department is not recommended for
the following reasons. First: The cardboard carton in which your PAXAR printer
was shipped allows the printer to be moved with a forklift, forkcart or hand cart.
Because of the weight of the printer, it is easier and safer to use one of these
devices to move the printer to its intended installation location. Second: Leaving
the printer in the carton while it is being moved within your facility will help to
protect the printer during any movements to this new location. Once the printer has
reached its intended location you should begin the unpacking process.
Open the printer from the top of the box (See Figure 1b). Do not cut deep into the
carton as there are items located just under the top. Remove the items located on the
top insert. Remove the top insert. Lift the printer onto the table with the two
banding straps. Remove the two straps and the plastic from the printer. Inspect the
machine for shipping damage. If obvious damage is discovered, contact PAXAR for
further instructions - in the U.S.A. at 570-888-9116. In other countries please
contact your local PAXAR supplier. Once you are satisfied that there was no
obvious shipping damage to the printer, the printer can now be lifted to its intended
location.