Filter
Top Products
6 • Printer Setup Users Manual Model 656/636
Printer Setup
Installing the Stacker
Remove the stacker from the separate packaging. Remove the packaging from
around the stacker and save with the rest of the printer packing supplies.
Swing open the top cover to the printer. Locate the large knob and two round pins
on the right hand side of the printer. Loosen the knob enough to allow the stacker to
slide between the printer housing and the knob. The stacker will rest on the two
pins. Slide the stacker to the back until it contacts the up-right frame. Tighten the
knob. Adjusting the stacker is covered later.
Install the stacker up-right rails. Remove one of the thumb screws. Insert the thumb
screw through the mating hole in the up-right rail assembly. Thread the thumb
screw into the mounting block. Repeat the above procedure for the other thumb
screw.
There is a harness and connector leading from the back of the stacker that plugs into
the center connector on the last PC board. The connector and plug are polarized.
Rotate the plug until the polarized plug and connector align and push them together.