Filter
Top Products
5-4 Care and Maintenance
4. Use a dry, soft-bristle brush, such as a toothbrush, to clean either the
standard (black) or linerless (red/orange textured) platen roller.
5. Turn the platen roller with your finger, and then continue cleaning.
6. Reload the supplies and close the label deflector and supply cover.
NOTE: DO NOT use alcohol or solvents on linerless (red/orange textured)
platen rollers.
If the brush does not remove all the adhesive:
♦ use isopropyl alcohol ONLY on the standard (black) platen roller.
Moisten a cotton swab with isopropyl alcohol and run the cotton swab
across the platen roller. Turn the platen roller with your finger to make
sure the platen roller is clean all the way around. After cleaning, feed
several inches of supply through without printing to remove any
remaining isopropyl alcohol.
♦ Call Service to clean the linerless (red/orange textured) platen roller.
Pinch and Feed Rollers
To clean the pinch and feed rollers:
1. Turn the printer off and open the supply cover.
2. Remove the supplies. See “Removing Supplies” in Chapter 3.
Platen Roller