Filter
Top Products
Care and Maintenance 5-5
3. Turn the platen roller with your fingers and run a dry, lint-free cloth
across the pinch and feed rollers as they turn. Make sure the rollers
are clean all the way around. If that does not work, use a cloth
dampened slightly with distilled water.
4. Reload the supplies after the printer dries.
Sensors
To clean the on-demand sensor:
1. Turn the printer off and open the supply cover.
2. Remove the supplies. See “Removing Supplies” in Chapter 3.
3. Open the label deflector by gently pressing down with two fingers.
4. Clean the on-demand sensor with a soft cloth moistened with water.
5. Reload the supplies and close the label deflector and supply cover.
On-Demand Sensor