Filter
Top Products
C1519M-D (3/06) 35
00931
CREATING ZONES
1. Move the joystick to Point A.
2. Select
DEF
from Main Menu 2 and enter your PIN, if necessary.
3. Select .
4. Enter a zone priority level (1-8) and select again. The icon becomes
highlighted signaling the start of zone creation. “Edit label. Ack-set for left
edge. Pan right. Press 81 & F5 for right edge.” appears on the monitor.
5. Press to scroll through the alphanumeric characters.
Each zone label can have up to 20 characters. Move the joystick to the right
to advance to the next character.
6. Move the joystick to SET and then to the right. The zone label appears on
the monitor.
7. Move the joystick to Point B. You should move the joystick from left to right
only.
8. Enter the priority level again and select . The icon returns to normal.
Repeat these steps if you want to create additional zones.
If you move the associated camera through the area defined by the zone
(approaching the zone edges from either direction), the zone label appears on
the selected monitor as you enter the zone and disappears as you exit the zone.
Refer to Figure 40.
Figure 40. Basic Zone Creation
NOTE:
To create zones when using
Spectra III cameras, you must enable
the zone label display in the Spectra III
menus.