Filter
Top Products
C1519M-D (3/06) 37
ZONE C
BEGINS
ZONE C
ENDS
ZONE A
BEGINS
ZONE B
BEGINS
ZONE A
ENDS
ZONE B
ENDS
RESULT
ZONE C
PRIORITY 6
ZONE B
PRIORITY 2
ZONE A
PRIORITY 5
ZONE A ZONE C
ZONE B
00933
NOTE: DO NOT
pan left or right
while erasing zones.
EMBEDDED ZONES
An embedded zone is a zone that is between two other zones. In Figure 42,
Zone C is embedded between Zone A and Zone B.
An embedded zone is not seen unless its priority level is higher than the priority
level of the other zones. Since Zone C has a priority level of 6, portions of Zone A
and Zone B are not seen.
Figure 42. Embedded Zones
TURNING ZONES ON AND OFF
Follow these steps to turn zones on and off:
1. Select
PRST
from Main Menu 1 to bring up the Preset Menu.
2. Select . “ZONES OFF” or “ZONES ON” appears.
3. Select again to either turn the zones off or on.
ERASING ZONES
1. Select
DEF
from Main Menu 2.
2. Select .
3. Enter the priority level of a zone you want to erase and select again.
4. Move the joystick down and select SET. The zone is erased.
Repeat these steps to erase other zones. You can also use these steps to start
over should you make a mistake during zone creation.