Filter
Top Products
42 C1519M-D (3/06)
MULTIPLEXER CONTROL
You can also control multiplexers with the KBD960 keyboard. You can connect
multiplexers to any input.
Refer to the CM6800 Installation/Operation Manual (C1515M) for instructions on
setting the multiplexers for keyboard control.
Follow these steps to control multiplexers:
1. Enter a MUX input number and press . Each MUX input is associated
with a camera input. Figure 43 shows MUX 1 being controlled.
2. Select
MUX
. MUX Menu 1 appears.
MUX
should be highlighted, which
means you have MUX control.
3. Cycle through the 16 picture inserts (if you have a 16-channel multiplexer)
by entering the camera number and selecting .
4. Select again to zoom into the MUX camera. You can move the joy-
stick to view a specific area.
5. Select to bring up MUX Menu 2. The icons for a picture-in-picture display,
4-camera display, 9-camera display, and 16-camera display appear.
6. Select to view four of the available 16 cameras on one monitor.
You can cycle through all 16 cameras, four at a time, by repeatedly selecting
.
7. Select to view nine of the available 16 cameras on one monitor.
Select again to see the remaining seven cameras.
8. Select to view all 16 available cameras on one monitor.
Figure 43. MUX Control Menu
LOG
O
FF
PRSTGPIMUX
1 1
00934
NOTE:
does not work on a
9-channel multiplexer.