Filter
Top Products
C3683M (3/09) 13
Equipment Placement and Rack Mounting
The NSM5200 can be placed on a flat surface, such as a desktop, or mounted in an equipment rack.
DESKTOP INSTALLATION
To install the NSM5200 on a desktop:
1. Make sure the rubber feet are installed to prevent surface damage. If not, secure each rubber foot to the bottom panel of the un
it (refer to
Figure 5). Use the five 8-32 x 0.375-inch Phillips pan head screws (supplied).
2. Remove the two chassis brackets from the s
ides of the unit, if they are attached. Remove the 10-32 x 0.25-inch Phillips pan head screws
(six per bracket). Save the brackets and screws for possible future use.
Figure 5. Installing Rubber Feet and Removing Brackets
3. Position the unit to allow for cable and power cord clearance at the rear of the unit.
WARNING: Do not place the NSM5200 on its side; in this position, the unit is likely to fall over and may cause equipment damage or
personal injury.
M
5200
REMOVE BRACKETS
AND SCREWS