C3683M (3/09) 23
Operation
Refer to the Web Browser manual that was shipped with the unit for details on how to access and configure the NSM5200.
NOTE: To make sure that all diagnostic messages will
appear to a system operator, leave at least one Endura workstation or VCD5000 running
at all times.
During operation, monitor the unit status and power supply indicator lights to make sure that all drives are operating properly. I
f failure occurs,
system alarms and error messages will also display on Endura workstations and VCD5000 video console displays.
Figure 19. Front Bezel Indicators
Figure 18. Front Panel Layout
FRONT PANEL CONTROLS AND INDICATORS
ì
Pelco Badge (power indicator)
The Pelco badge glows blue when the unit has power. If the front bezel is open, this indicator glows white.
î
Drive Status
The drive status indicator reports the operating status of each individual hard drive as follows:
• Solid Green: The read or write operation on a specific hard drive.
• Solid Red: A problem exists with the hard drive.
• Flashing Red: The unit is initializing the hard drive.
ï
Mute Button
Press the mute button to silence an alarm. The user must press the mute button for each alarm event.
ñ
Power Button
Use the power button to turn the unit on and off (refer to Unit Startup on page 25 and Unit Shutdown on page 25).
ó
Compact Flash Drive
Contains the Web configuration software
r
Compact Flash Eject Button: Use this button to remove the CompactFlash drive.
1 2 3 4 5 6 7 8 9
10 11 12
NSM5200