Filter
Top Products
C3683M (3/09) 9
Before You Begin
Endura is a network system that requires a continuous amount of bandwidth to transmit true, live video; therefore, always include your network
administrator when planning and installing Endura components.
You will need the following items:
• Pelco-approved Endura certification
• Access to an Endura network that is
– an active, Gigabit Ethernet network that supports the full Internet Protocol suite,
– configured with at least one Endura system manager, and
– configured with at least one Endura workstation
NOTES:
• For best results, make sure your installation meets the power, environmental, and networking guidelines described in the
Endura Installation Guidelines and Best Practices document.
• When using one or more network switches on the Endura network, enable autonegotiation on all switches.
• These network requirements represent the minimum standard for a small En
dura-capable security network. Consult the Endura Network
Design Guide to make sure your network is properly configured. Your system might require additional hardware, software, and network
resources.
PARTS LIST
Qty Description
1 NSM5200 Series network video recorder
2 Hard drive packs (6 filled hard drive carriers each)
1 Accessory pack:
5 Rubber feet with 8-32 x 0.375-inch, Phillips pan head screws (for desktop mounting, installed)
2 Power cords either 2 US (North American), 2 European standard, 2 UK standard, 2 Australian, or 2 Argentinian
NOTE: Units shipped to China do no
t include power cords.
2Front bezel keys
1 Disposable wrist strap for electrostatic discharge (ESD) protection
1 Rack mount kit (included with accessory pack):
2 Chassis mounting brackets with ha
ndles and thumbscrews (installed)
12 Screws, 10-32 x 0.25-inch, Phillips pan head (six for each bracket, installed)
2 Adjustable support rail sets (each set includes one front-mounting rail and one rear-mounting rail)
8 Screws, 8-32 x 0.375-inch, Phillips truss head (four for each support rail)
8 Screws, 10-32 x 0.5-inch, Phillips flat head
(two for each front rail, two for each rack rail spacer)
4 Screws, 10-32 x 0.75-inch, Phillips pan head (two for each rear rail)
1 Cable management bracket
2 Screws, 6-32 x 0.25-inch, Phillips pan head
2 Rack rail spacers
14 Cage nuts, 10-32
3 Product serial number labels (attached to unit)
1 NSM5200 Series Network Storage Manager Installation manual
1 Web Configuration manual
1 Safety instructions