Filter
Top Products
6-5
Operation
To switch plugs On/Off, initiate a reboot cycle, or set plugs to their Power Up
Default values, proceed as follows:
1. Switch Plug(s) On: Type /ON n and press [Enter]. Where "n" is the
number or name of the desired plug. For example:
/ON 1 or /ON ROUTER
2. Switch Plug(s) Off: Type /OFF n and press [Enter]. Where "n" is the
number or name of the desired plug. Note that the "/OFF" command
can also be entered as "/OF". For example:
/OFF 2 or /OF ROUTER
3. Boot Plug(s): To initiate a reboot cycle, type /BOOT n and press
[Enter]. Where "n" is a the number or name of the desired plug. Note
that the "/BOOT" command can also be entered as "/BO". For example:
/BOOT 1 or /BO ATMSWTCH
4. Set Plugs to Power Up Defaults: Type /D and press [Enter]. Plugs
will be set to their default On/Off status (Power Up Default), which is
defined sing the Plug Parameters Menu as described in Section 5.3.3.
Notes:
• When you have accessed command mode using the System
Password, the Default command will be applied to all plugs.
• When you have accessed command mode using a Plug (User)
Password, the Default command will only be applied to the
plugs permitted by the password.
5. Suppress Command Confirmation Prompt: To execute a switching
or reboot command without displaying the "Sure?" prompt, include the
",Y" option at the end of the command line. For example:
/ON ROUTER,Y or /BOOT 2,Y