Filter
Top Products
C. I have another IP Address displayed
If you have another IP address listed then the PC may not be configured for
a DHCP connection. Please refer to “Configuring Client TCP/IP” for
information.
Once you have confirmed your computer is configured for DHCP, then
please follow the steps below.
1. Open a DOS window as described above.
2. Type ipconfig/release.
3. Then type ipconfig/renew.
D. The 10/100 LED does not light after a connection is made.
1. Check that the host computer and the Wireless Base Station 11g are
both powered on.
2. Be sure the network cable is connected to both devices.
3. Verify that Category 5 cable is used if you are operating at 100 Mbps.
4. Verify that the length of any cable does not exceed 100 m (328 ft).
5. Check the network card connections.
6. The RJ-45 port on the Wireless Base Station 11g, network card, or cable
may be defective.
E. Browser Configuration
Confirm your browser is configured for a direct connection to the Internet
using the Ethernet cable that is attached to the computer.This is configured
through the options/preference section of your browser.
5757
ENGLISH