Open as PDF
Press the STANDBY/ON/OFF button to switch on the projector.
– The lamp indicator
flashes green and the
start up screen appears
for 5 seconds.
– When the average
lamplife time has almost
expired and less than
100 hours remain, the
lamplife has almost
expired’ will be displayed
on the screen when
switching the projector
on. For this refer to the
section ‘Lamp’ under
– When the lamp is on, the lamp indicator lights up green.
If you use the optional trackball remote control:
– Set the ON/OFF switch of the remote control to ON in order
to switch on the remote control.
– If required, press the light button of the remote control.
When this button is pressed, the button illumination is
switched on for 5 seconds. Every time one of the buttons is
pressed within these 5 seconds, the illumination time is
extended by a further 5 seconds.
Select the required source (Data, Video or S-Video) by
pressing the corresponding source selection button.
Note: The source selection button VIDEO of the optional
trackball remote control toggles between Video and S-
Switch on the computer or start video playback.
– A feedback message appears on the screen, indicating the
Feedback messages - General explanation
Feedback messages are displayed in the top right corner of the
screen. They are displayed when:
– a signal comes up or goes down,
– when an input source is changed
– when the A/V Mute or the Mute functions are toggled.
– when the Auto image function is set to ON.
These messages will only be displayed when the menu option
FEEDBACK is set to ‘on’ in the SETTINGS menu. All messages,
except the A/V Mute message, will be removed automatically
after 4 seconds.
Data selected as source. Video selected as source, no
S-Video selected as source. Video selected as source,
A/V muted Mute
Error messages - General explanation
Error messages are
displayed in the centre of
the screen. The problem is
described in the header of
the message display.
Suggestion(s) to solve the
problem are displayed in the
gray part of the message
On Screen Display menu - General explanation
All video and data adjustments and settings (except A/V Mute)
are done via On Screen
Displays and with help of
MENU, OK (–/––) and
Cursor Control on the
projector or the remote
– The menu bar appears on the screen.
The first item is
highlighted and its sub
menu is shown.
Depending on the
selected source (Data,
Video or S-Video) some
options of the submenu
may be greyed out. This
indicates that these
– are not available in a
– have no function for
the selected source.
– HORIZONTAL SIZE under submenu DISPLAY when AUTO
IMAGE is switched to ON.
– HUE under submenu PICTURE when signaltype is not NTSC.
The projector will switch off automatically.
Please contact a service centre for repair.
Picture Audio SettingsDisplay
Auto Image is used to automatically adjust Size...,
Phase and Shift....