Filter
Top Products
28
English
Tuning to radio stations
1 Press SOURCE on the unit repeatedly or
press TUNER on the remote control
repeatedly until the desired waveband
(TUNER FM or TUNER AM) is displayed.
2 Press and hold 4 or ¢ for more than
a half second, then release.
➜ The unit automatically tunes to the next
station with sufficient signal strength.
➜ = lights up when receiving a stereo
signal (in FM waveband only).
3 Repeat step 2 until you find the desired
station.
00
To tune to a station with a weak signal
press 4 or ¢ briefly and repeatedly
until an optimal reception is found.
Storing radio stations
You can store up to 40 radio stations in the
memory, starting from FM and followed by AM
wavebands. Stations can be stored automatically
or manually, or by using the “Plug and Play”
function. If no button is pressed within 20
seconds the unit will exit from the storing
mode.
Storing by using “Plug and Play”
You can store all available radio stations
automatically. Attention:All previously
stored radio stations will be replaced.
1 Connect the unit to the power supply.
➜ TUNER and AUTO INSTALL - PRESS
PLAY are displayed.
or
In standby mode press and hold ÉÅ on
the unit until TUNER and AUTO INSTALL
PRESS PLAY are displayed.
2 Press ÉÅ on the unit to start the
installation.
➜ TUNER INSTALL is displayed and
automatic searching and storing starts.
➜
During searching TUNER AUTO is displayed.
➜ As soon as a radio station is found and
stored the frequency and the waveband
will be displayed.
➜ Once completed, the last tuned radio
station will be played.
Note: If no stereo signal is detected CHECK
ANTENNA is displayed.
Tuner
AUX PC LINKTUNERCD
CD2
CD
3
CD5
CD4
CD
1
SHUFFLEPROGRAMREPEAT DISPLAY
ALBUM
BROWSE
VOL
MC W770/37.1 us eng 8/13/04 17:32 Page 28