Filter
Top Products
Usin
g
your Pro
g
rammable Power Supply 5 - 23
• SOLUTION:
Press to enter the STEP submenu.
Check that the AUTO STEP is OFF, or press the OFF (0) key to set the
AUTO STEP function off.
Press to leave the STEP submenu.
Press (only for multiple output models) to select output channel 1.
Press to enable output channel 1.
Press (only for multiple output models) to select output channel 2.
Press to disable output channel 2.
Press as many times as necessary to select output channel 1 a
g
ain.
Press to make the OPERATE mode active.
Press to enter the step mode.
Press to select start address 20 of the list.
The display reads: 1 S T E P 2 0 . . . . . . .
LOOP: Press if you want to see the actual volta
g
e on output
channel 1 at the memory address as indicated on the display.
Press if you want to see the actual current from output
channel 1 at the memory address as indicated on the display.
Press to select the next memory address of the list.
Repeat this loop until step 40 is made active.
ENDLOOP
Press to select output channel 2.
The display reads: 2 S T E P 4 0 D I S
Press to leave the step mode.
Remark: When the next step is executed, the next volta
g
e and current
settin
g
in the list is made active and output on the selected
channel.
Automatic step function
Local control (automatic steppin
g
):
The AUTO STEP function, the CONTINUOUS STEP function, the step interval
time, the START address, and the STOP address can be set via the key.
The automatic step function can be started by pressin
g
the key.
AUX
ENTER
ENTER
SELECT
ENABLE
DISABLE
SELECT
ENABLE
DISABLE
SELECT
OPR
STBY
STEP
2
0
ENTER
V
I
STEP
SELECT
AUX
STEP