Filter
Top Products
36
EN
Question
My SGC2909 does not work in my MS-DOS based game.
Answer
USB Devices do not function in MS-DOS
USB devices do not function under the MS-DOS environment.
There is no way to get an MS-DOS game to recognize a USB device.
------------------------------------------------------------------------------------------------------------
Question
I extended the cable of my SGC2909 and now the SGC2909 stopped working in my PC Game or my PC game froze.
Answer
Do not extend or retract the connection cable of the SGC2909 while it is connected to a USB port.
The cable length should be adjusted before you connect the SGC2909 to your USB port. Adjusting the length
while the SGC2909 is connected to a USB port can cause your PC and game to lose connection with the
SGC2909. If this occurs, you can try the tips below.
• If the PC Game stops responding to the SGC2909 coil, this indicates that the connection may have been lost
due to extending or retracting the connection cable. Wait several seconds and the SGC2909 d should auto-
matically reconnect. If this doesn’t work, you will need to exist the PC game and restart it. If this occurs while
you are using the SGC2909 with a game prole, the loaded prole will be lost. You would then need to exist
the PC game, restart the SGC2909 Prole Editor and reload the prole. You then can restart your PC game.
• If your software title freezes or hangs up due to extending or retracting the cable you will need to try the
following. Wait several seconds and the SGC2909 should automatically reconnect. If this doesn’t work try un-
plugging the USB connector and then reconnecting to the same USB port. If the above tip does not work, then
you will have to exist the software title. Press Ctrl and Alt keys down at the same time and then press the Del
key. Try closing down the software title. If this does not work you will need to restart your PC.
Please do not extend or retract the SGC2909’s cable while it is connected to the USB port. If you need to adjust
the length you should exit the PC game. Unplug the SGC2909 from your USB port and adjust the cable to the
desired length. Plug the SGC2909 to your USB port and restart the PC game. If you were using a custom prole
you will need to restart the SGC2909 Prole Editor and reload the same prole.
------------------------------------------------------------------------------------------------------------
Question
The Enter and Esc buttons on my SGC2909 do not work. What do they do?
Answer
SGC2909 software must be installed.
You must install the SGC2909 software. If the software is not installed, these two buttons will not function. The
Enter and Esc buttons will provide the same function of the Enter and Esc keys on your keyboard. Enter and Esc
is usually used to navigate through the game menus.
FAQs