Filter
Top Products
16
En
English
Operations
Selecting an Input Source
This section explains the basic operation of the plasma
display. Outlined on the following pages is how to turn
the main power on and off, put this display in the
operation or standby mode and how to select connected
components.
Before you begin, make sure you have:
•
Made connections between the plasma display and AV
components or personal computer as described in the
section “Installation and Connections” starting on page 6.
• Set up the on-screen menu to input signals from
components connected to INPUT1, INPUT2 and
INPUT5 as described in the section “Setting Up the
System” on page 14.
If no connections are made to these terminals,
on-screen setup is not necessary.
2,5
3
1 Switch MAIN POWER on the display to the on
position to turn the main power on.
The STANDBY/ON indicator lights red.
2 Press STANDBY/ON to put the plasma display in
the operation mode.
The STANDBY/ON indicator turns green.
Operations
3 Press INPUT on the remote control unit or the
display to select the input.
Input changes each time the display’s INPUT is
pressed as follows.
• When the menu screen is displayed, changing the
signal input will cause the menu screen to turn off.
• If the input computer signal is not supported by the
display, the following message will be displayed:
:
085
512 684
k
HzfV .
:
17
1
7
HzfH .
POUSUPNSREDTINALG
CAU IONT
FULL
INPUT
1
X
:
020
––––
k
HzfV .
:
77
1
5
HzfH .
TOU NOARFGE
CAU IONT
FULL
INPUT
1
4 Use VOLUME +/– on the remote control unit to
adjust the volume.
If no audio connections are made to the plasma
display, this step is not necessary.
5 When viewing is finished, press STANDBY/ON to
put the display in standby mode.
The STANDBY/ON indicator will blink and then remain
lit (red) indicating that the standby mode is engaged.
Operation is not possible while the STANDBY/ON
indicator is blinking (red).
6 Switch MAIN POWER on the display to the off
position to turn the main power off.
The STANDBY/ON indicator may continue to light for a
short while even after the main power is turned off.
This is a result of residual electric load impressed on
the circuitry, and the light will turn off presently.
CAUTION
Please do not leave the same picture displayed on the screen for
a long time. Doing so may cause a phenomenon known as
“screen burn” which leaves a ghost, or residual, image of the
picture on the screen.
Remote Control UnitDisplay Operating
Panel
2,5
3
4
3 INPUT1
INPUT5 2
3 INPUT2 3 INPUT3
INPUT4 2