Filter
Top Products
3-9SV61027 Rev. D
DA700/DA750 Features and Adjustments • 3
Whenever you switch from one material type to another, you
need to set the gap between the separators and the feed
roller before printing begins.
NOTE: There are three positions of the "H" Blocks.
• Lever fully down - adjusted to media thickness (ready
to operate).
• Lever midpoint - not adjusted to any media (free
floating on media, not set up to operate).
• Lever fully up - locked in the up position, not adjusted
to any media thickness.
1. Set the
Separator Gap
Setting Up A Job
(continued)
Setting the Proper Feed Gap
1. Loosen the lock knobs to unlock all three H-Blocks.
2. Lift the H-Blocks to their highest position and lock in
place.
3. Place a sample piece of material between the sepa
-
rator fingers (the lower section of the H-Blocks) and
the feed roller.
H-Blocks