Installation
3. Connect ADSL Cable
Connect the supplied ADSL cable from to the WAN port on the ADW-4302v2 (the
RJ-11 connector) to the ADSL terminator provided by your phone company.
4. Power Up
Connect the supplied power adapter to the ADW-4302v2. Use only the power
adapter provided. Using a different one may cause hardware damage.
5. Check the LEDs
• The Power LED should be ON.
• The Status LED should flash, then turn Off. If it stays on or blinking after 60 sec-
onds, there is a hardware error.
• For each LAN (PC) connection, one of the LAN LEDs should be ON (provided the
PC is also ON.)
• The WLAN LED should be ON.
• The WAN LED should be ON if ADSL line is connected.
• The Internet LED may be OFF. After configuration, it should come ON.
For more information, refer to Front-mounted LEDs in Chapter 1.
7