Filter
Top Products
PC Configuration
Wireless Station Configuration
This section applies to all Wireless stations wishing to use the ADW-4302v2's Access
Point, regardless of the operating system which is used on the client.
To use the Wireless Access Point in the ADW-4302v2, each Wireless Station must
have compatible settings, as follows:
Mode The mode must be set to Infrastructure (rather than Ad-hoc)
Access points only operate in Infrastructure mode.
SSID (ESSID)
This must match the value used on the ADW-4302v2. The default
value is Wireless.
Note! The SSID is case sensitive.
Wireless
Security
By default, Wireless security on the ADW-4302v2 is disabled.
• If Wireless security remains disabled on the ADW-4302v2, all
stations must have wireless security disabled.
• If Wireless security is enabled on the Wireless Router (either
WEP or WPA-PSK), each station must use the same settings
as the ADW-4302v2.
Wireless Configuration on Windows XP
If using Windows XP to configure the Wireless interface on your PC, the configuration
procedure is as follows:
1. Open the Network Connections folder. (Start - Settings - Network Connections).
Figure 26: Network Connections (Windows XP)
2. Right-click the Wireless Network Connection, check that it is enabled (menu
option says Disable, rather than Enable) and then select View Available Wireless
Networks.
3. You will then see a list of wireless networks.
37